[ REQ 5891]: Please help about Geomview

[ebihara at c3007.tokai.jaeri.go.jp]

Dear Sir.

I tried to compile Geomview on Silicon Graphics WS
that is the Indigo^2 IMPACT workstation.
Although compileing has finished,
the File panel for the file management in which
the data file can be loaded and saved dose not
response for mouse clicks. Then the data file
can not be loaded and saved.
The data file can be loaded from command line
in the following way:
    >> geomview data.off

There is another problem. When I tried to normalize
geometry in the Obscure Panel, the machine hanged up
and shuted down automatically.

I am very happy if you give me some advices about these
problem.


Kind regards


================================================================ 
=                     Kenichi Ebihara
=
= Center for Promotion of Computational Science and Engineering
=                   TOUKAI Establishment
=        JAPAN ATOMIC ENERGY RESEARCH INSTITUTE (JAERI)
=
=        Tokai-mure,  Naka-gun, Ibaragi, JAPAN  319-11
=           Tel +81-29-282-5434 Fax +81-29-282-6070
================================================================